Dinion2X IP Camera
A low (negative) value means that the camera switches to
monochrome at a lower light level. A high (positive) value
means that the camera switches to monochrome at a higher
light level.
Priority
In Auto switching mode, set the camera priority to either:
–
Color: the camera gives color pictures as long as the light
level permits.
–
Motion: the camera gives sharp images without motion
blur as long as the light level permits (it switches to
monochrome earlier than it would with Color priority).
The camera recognizes IR-illuminated scenes to prevent
unwanted switching to color mode.
IR contrast
There are two modes for IR contrast:
–
Enhanced: the camera optimizes contrast in applications
with high IR illumination levels. Select this mode for IR
(730 to 940 nm) light sources and for scenes with grass
and green foliage.
–
Normal: the camera optimizes contrast in mono
applications with visible light illumination.
Color burst
–
Off: the color burst in the video signal is switched Off in
monochrome mode.
–
On: the color burst remains active even in monochrome
mode (required by some DVRs and IP encoders).
9.6.5
Enhance
Dynamic engine
–
Off: turns off all automatic scene detail and enhancements
(only recommendedfor testing).
–
XF Dynamic: extra internal processing is enabled for low-
light applications (traffic, etc.).
–
2X Dynamic: 2X Dynamic adds dual sensor exposure to the
XF Dynamic features. In harsh lighting conditions pixels
Bosch Security Systems
This manual downloaded from http://www.manualowl.com
Installation and Operation Manual
Advanced Mode | en
AR18-10-B006 | v1.1 | 2010.06
73