Delivery Set; Technical Specifications - Vitek VT-3419 W Manual Instruction

ENGLISH
Unplug the unit.
–
Disconnect the motor unit (2) from the
–
geared lid (5) chute by turning the motor
unit (2) counterclockwise.
Remove the geared lid (5).
–
Carefully remove the chopping knife (7) tak-
–
ing it by the plastic end.
Take the chopped food out of the chopper
–
bowl (6).
ATTENTION!
Strictly follow the described sequence of oper-
ations.
To achieve the best results,
refer to the table below:
Product type Weight,
g
Meat 200
Herbs 50
Nuts 150
Cheese 100
Bread (rusks) 80
Onions 200
Cookies 150
Soft fruit 200
Note: all data in this table are given as recom-
mendations.
CLEANING
Attention! The blades of the chopping knife (7)
are very sharp and may be dangerous.
Handle the chopping knife (7) very care-
fully!
Unplug the unit before cleaning.
1.
Remove the attachments. Use a slightly
2.
damp cloth to clean the motor unit (2) and
the gears (5, 8), then wipe them dry.
After processing salty or sour products, it
3.
is necessary to rinse the blender attach-
ment (1) or the chopping knife (7) with water
immediately.
While possessing products with strong dye-
4.
ing properties (for instance, carrot or beet-
root) the attachments and bowls can get
colored, wipe the attachments and the bowls
with a cloth dampened in vegetable oil; after
that wash the attachments and bowls with a
neutral detergent.
IM VT-3419.indd 6
5.
6.
STORAGE
•
•
Approximate
•
processing time,
seconds
15

DELIVERY SET

Motor unit – 1 pc.
10
Blender attachment – 1 pc.
15
Whisk gear – 1 pc.
10
Whisk attachment – 1 pc.
10
Geared lid – 1 pc.
Chopping knife – 1 pc.
10
Chopper bowl – 1 pc.
10
Measuring cup – 1 pc.
10
Instruction manual – 1 pc.

TECHNICAL SPECIFICATIONS

Power supply: 220-240 V ~ 50/60 Hz
Power consumption: 800 W
The manufacturer preserves the right to
change the specifications of the unit without a
preliminary notification.
Unit operating life is 3 years
Guarantee
Details regarding guarantee conditions can be
obtained from the dealer from whom the appli-
ance was purchased. The bill of sale or receipt
must be produced when making any claim un-
der the terms of this guarantee.
6
Wash the attachments that contacted prod-
ucts with warm water and a neutral deter-
gent and dry them thoroughly after use.
Wash the whisk attachment (9) all over and
wash only the lower part of the blender
attachment (1).
Do not immerse the motor unit (2) and the
gears (5, 8) into any liquids, do not wash
them under water jet or in a dishwashing
machine.
Clean and dry the unit thoroughly before tak-
ing it away for long storage.
Do not wind the power cord around the
motor unit (2).
Keep the blender set away from children in
a dry cool place.
This product conforms to the EMC-
Requirements as laid down by the Council
Directive 2004/108/ЕС and to the Low
Voltage Regulation (2006/95/ЕС)
06.09.2016 11:17:34