Table of Contents
Advertisement
ASSEMBLY
NEVER point the spray gun at any part of the body.
ASSEMBLY
Make sure the power cord is unplugged.
Attention
1.
Insert the suction tube into the intake opening.
2.
Align the pickup tube:
A If spraying downward, the angled end of the pickup tube should be
pointing toward the front of the nozzle.
B If spraying upward, the angled end of the pickup tube should be
pointing toward the rear of the nozzle.
Make sure the pickup tube is inserted as far as it will go
i
to ensure a tight fit.
3.
Carefully screw the cup back onto the nozzle assembly. Tighten firmly.
4.
Align the nozzle and the handle approximately as shown.
5.
Insert and twist the nozzle into the handle toward the "lock" symbol
on the handle.
The tab below the trigger will lock the two pieces into place.
6.
Insert the air hose tightly into the air hose port in the Power Box.
Turn the Power Box switch ON (I). Turn switch on handle to ON (I). The
turbine will not run until handle switch is set to ON (l).
Do not pull trigger at any time if the turbine is not
i
running.
5
1
2
A
3
4
6
EN
B
7
Advertisement
Table of Contents
