Under this symbol you can find important information on how to EXPLANATORY DIAGRAM _____________________ 5 avoid injuries and damage to the device. THE WAGNER CLICK&PAINT SYSTEM ___________ 5 Indicates tips for use and other particularly useful information. 3.1 Disassembly of the spray gun ____________________5...
FinishControl 5500 SAFETY REGULATIONS c) Avoid accidental starting-up. Ensure that the switch SAFETY REGULATIONS is in the “OFF” position before inserting the plug into the socket. Accidents can occur if you carry the power tool while your finger is on the switch or if you connect the power All local safety regulations in force must be observed.
Page 8
FinishControl 5500 SAFETY REGULATIONS personnel and only with original spare parts. This Protective clothing, gloves and, if necessary, protective skin ensures that the tool safety is maintained. cream is required to protect the skin. b) If the supply cord is damaged, it must be replaced by 4.
THE WAGNER CLICK&PAINT SYSTEM With the Wagner Click&Paint System, the front part of the gun (spray attachment) can be replaced quickly and easily. This enables a rapid material change without cleaning, and ensures that the right tool is available for every material and applica- tion.
FinishControl 5500 TECHNICAL DATA/ INTRODUCTION/ PREPARING THE COATING MATERIAL TECHNICAL DATA COATING MATERIAL COATING MATERIALS SUITABLE FOR USE Voltage: 230 V~, 50/60 Hz Solvent-based and water-soluble lacquer paints Power consumption: 1150 W Mordants, glazes, impregnations, oils, clear varnishes, syn- Max. current consumption...
FinishControl 5500 SETTING THE SPRAY GUN /STARTING OPERATION/ SPRAYING TECHNIQUE Anti-rust paints, spe- observe manufac- When working on lying objects: cial-effect paints turer’s instructions Turn the feed tube forwards. (Fig. 7 A) Spraying work when working on overhead objects: Multicolor paints,...
FinishControl 5500 BREAKS IN WORK/ TRANSPORTATION/ TAKING OUT OF OPERATION AND CLEANING BREAKS IN WORK 9. Clean the air cap (fig. 14, 1) and nozzle (3) with a brush and solvent or water. Take special care when cleaning the interstices on 1.
FinishControl 5500 MAINTENANCE 13.2 AIR RELIEF VALVE Warning If paint has entered the ventilation hose, proceed as follows: If the supply cord of this appliance is damaged, it must only be replaced by a repair shop appointed by the manufacturer, because special purpose tools are required.
FinishControl 5500 CORRECTION OF MALFUNCTIONS CORRECTION OF MALFUNCTIONS MALFUNCTION CAUSE REMEDY • • The unit will not start No mains voltage Check • • Device overheated Unplug the power plug, let the device cool down approx. 30 minutes, do not bend the...
With the Can Adapter, paint cans can be attached directly to a Click&Paint spray attachment. Suitable for: commercially available 750 ml paint tins (maximum dimensions Ø=102 mm, h=119 mm) and 1000 ml paint tins (maximum dimensions Ø=112 mm, h=132 mm). 15.2 SPARE PARTS FINISHCONTROL 5500 (FIG. 21) ORDER NO. POS. DESIGNATION...
Wagner or one of our dealers will take back your used Wagner waste electrical or electronic equipment and will dispose of Subject to modifications it for you in an environmentally friendly way.