Breaks In Work; Transportation; Taking Out Of Operation And Cleaning; Assembly - WAGNER FINE COAT 9700 Operating Manual

EN
BREAKS IN WORK/ TRANSPORTATION/

TAKING OUT OF OPERATION AND CLEANING

10

BREAKS IN WORK

1. Turn the material regulator knob all the way to the right.
The paint spray gun is then secured against accidental
activation.
2. Switch device off with main switch on the basic unit.
3. Insert spray gun into gun mounting on the device.
In using quick-drying or two-component coating
materials, do not fail to rinse unit through with
a suitable cleaning agent during the processing
period.
Important: The application life of the material can
change as a result of heating. Therefore, please
consult the material manufacturer.
11

TRANSPORTATION

1. Coil power cable around the basic unit.
2. Insert spray gun into gun mounting on the device.
3. Unscrew the air hose from the base unit.
4. Roll up the air hose and tie it up with the fastening strap.
12
TAKING OUT OF OPERATION AND
CLEANING
1. Turn the machine off.
2. Unscrew the container.
Empty the remaining coating material into the original
container.
3. Unscrew feed tube with container seal. (Fig. 14)
The enclosed brush set can be used for particularly
effective cleaning of the spray attachment (examples
Fig. 15 and 16).
4. Clean the suction tube and intake support with a cleaning
brush. (Fig. 15)
5. Clean the ventilating bore. (Fig. 14, 2)
CAUTION! Never clean seals, diaphragm
and nozzle or air holes of the spray gun
with metal objects.
The ventilation hose and diaphragm are
only solvent-resistant to a limited extent.
Do not immerse in solvent, only wipe.
6. Unscrew the regulator ring (Fig. 2, 4) and remove the air
cap (3) and spring plate (5).
7. Unscrew the nozzle. (Fig. 3)
8. Clean the air cap, nozzle and needle with a brush and
solvent or water. (Fig. 16)
18
Take special care when cleaning the interstices on
the needle (Fig. 16, 7)
9. Clean the outside of the spray gun and container with a
cloth soaked in solvent or water. Use the all-purpose brush
for the thread (Fig. 16, 6).
10. Lightly lubricate at the marked points with silicone-free oil
(Fig. 17).
11. Assemble the parts again (see "Assembly").
12.1

ASSEMBLY

ATTENTION! Follow the steps described
below exactly for assembly. Otherwise
the gun may be damaged.
1. Insert the nozzle into the gun and tighten it.
2. Insert the spring plate and air cap and screw the regulator
ring to the gun.
3. Screw the feed tube with the container seal into the body
of the gun.
If the paint spray gun is not going to be used for a
while, it should be preserved with silicone-free oil
after cleaning.
FineCoat 9700