WAGNER FLEXIO 5000 Owner's Manual page 13

CLEANUP (CONTINUED)
CLEANING THE NOZZLE
1.
Make sure power cord is unplugged.
Remove the air hose from the turbine. Push the tab below
the trigger, twist and separate the handle from the turbine.
Wipe the exterior of the cup and nozzle until clean.
2.
iSpray Nozzle only -
a. Remove the air cap (a) by prying it off the connecting nut
(inset). Loosen the connecting nut (b).
b. Remove the parts as shown. Clean all parts with a cleaning
brush and the appropriate cleaning solution.
Reassemble all parts when clean.
3.
Detail Finish Nozzle only -
a. Unscrew the nut and remove the air cap and nozzle.
Remove the parts as shown(*). Clean all parts with a cleaning
brush and the appropriate cleaning solution.
Reassemble all parts when clean(**).
4.
Both nozzles - Clean the air vent (c) on the suction tube with
a soft bristled cleaning brush or toothpick.
5.
Both nozzles - Clean the rear of the nozzle (d) with the
appropriate cleaning solution. Use a thin layer of petroleum
jelly to lubricate the O-ring (e).
3
(*)
The nozzle seal may become
*
stuck inside the Detail Finish nozzle
when the nozzle is removed. If this
occurs, make sure to pull it out.
4
(c)
ISPRAY
DETAIL FINISH
(**)
It is important that the nozzle
**
seal inside the nozzle be re-installed
properly. Make sure the cup side of
the seal (the side with the groove) is
facing out towards the front of the
nozzle. Improper installation will
cause leakage and damage to the
turbine.
EN
1
2
(b)
(a)
5
(e)
(d)
ISPRAY
Groove
DETAIL FINISH
(e)
(d)
13