Table of Contents
Advertisement
MATERIAL PREPARATION
Material to be sprayed may need to be strained to remove any impurities in the paint which may enter and
i
clog the system. Impurities in the paint will give poor performance and a poor finish.
Thinning the material may be necessary but only after attempting to achieve optimal spray performance by
adjusting the various controls.
TO PREPARE THE MATERIAL
1.
Stir the spraying material thoroughly.
2.
Unscrew the cup from the nozzle.
3.
After the material has been properly thinned* and strained,
fill the container to desired level.
*THINNING THE MATERIAL
For certain spraying situations or desired finishes, thinning the
material may be desired. It is not necessary for most materials
when used with the iSpray nozzle. For use with the Detail Finish
nozzle thinning may be needed to achieve a finer finish. Make
sure you adjust the X-Boost™ and Material flow settings for your
specific material needs.
If thinning is necessary, use water for water-based materials,
mineral spirits for oil-based materials. Never exceed the
thinning advice given by the coating manufacturer.
Do not thin with materials that have a
flashpoint below 100°F (38°C).
6
1
2
3
EN
Advertisement
Table of Contents
