Fitting The Thermostatic Valve Assembly - Elisa Emilie Manual

Fitting the thermostatic valve assembly

(All models)
Elisa Emilie and Rosa
TM TM
Offer the thermostatic assembly up to
the Aquahub body and secure into
TM
place using the long allen key provided
and the bolts.
Tighten all bolts incrementally in a
clockwise manner until tight.
Ensure 'H' (as circled)
is on the hot water inlet
side (normally left-hand
side as viewed from
the front).
If the water supplies
are reversed or have
been plumbed incorrectly,
the shower will not blend
the water correctly as
the supplies do not
correspond with
the inlets of the
thermostatic assembly.
This can be easily corrected by
installing the assembly upside-down
(so the 'H' and 'C' is on the bottom)
- as shown.
Installation Guide | 9
TM
UK