Fitting The Control Dial (Push Button Models) - Elisa Emilie Manual

12 | Elisa Emilie
TM
Fitting the control dial
UK
Installation Guide
and Rosa
TM TM
(Push button models)
Fit the white spacer ring and flow
5.
control dial before placing the
temperature override cam onto the
shaft. Ensuring it is in the correct
orientation(vertical – as shown).
Place the second white spacer and
6.
the temperature dial onto the shaft,
with the pin vertically aligned.
Using the small allen key provided,
7.
tighten the grub screw to secure the
dial, then press in the silicone cap.
Open the water isolation valves
and test.
Note: Silicone can be applied
around the wall plate apart from the
drainage hole at the bottom. This
must be left uncovered.