User instructions
Dial models
Turning On and Off (Top dial):
Rotate the dial to select the required outlet; for multi outlet products the outlet
•
selection can be changed during showering, with off positions between each
outlet. Note the flow will be reduced/increased as the dial is turned towards the
off/outlet position respectively.
Adjusting temperature (Bottom dial):
To increase the output temperature, rotate the dial anti-clockwise.
•
For temperatures over 38°C, the pin can be depressed so that the dial
can rotate past vertical (CAUTION as this may cause scalding!).
To lower the output temperature, rotate the dial clockwise.
•
Flow control (Top Dial):
To reduce the flow, slowly rotate the dial towards the off position.
•
Max flow is achieved when the dial is pointing to the outlet.
Push button models
Turning On and Off (Top dial):
Push and fully depress the required button to select the desired outlet, pressing
•
again will stop the outlet. Outlet selection can be changed during showering
and multiple outlets can be run simultaneously.
•
Note: Whilst the shower is running, pressing another outlet button does not
automatically shut the outlet already in use, this must be pressed (de-selected)
to turn off.
Adjusting temperature (Bottom dial):
To increase the output temperature, rotate the dial anti-clockwise.
•
For temperatures over 38°C, the pin can be depressed so that the dial can
rotate past vertical (CAUTION as this may cause scalding!).
To lower the output temperature, rotate the dial clockwise.
•
Adjusting flow control (Ring behind temperature dial):
Flow can be adjusted between 0 and 100% by rotating the dial clockwise.
•
Elisa
Emilie
and Rosa
TM
TM
TM
Installation Guide | 23
UK