Table of Contents
Advertisement
X10DRL-LN4 Motherboard User's Manual
3. Insert the USB stick into a USB port, boot to the UEFI Built-In Shell, and type
the following commands to start the BIOS update:
Shell> fs0:
fs0:\> cd UEFI
fs0:\UEFI> flash.nsh BIOSname#.###
4. The FLASH.NSH script will compare the Flash Descriptor Table (FDT) code in
the new BIOS with the existing one in the motherboard:
a. If a different FDT is found
•
A new file, STARTUP.NSH, will be created, and the system will automatically
reboot in 10 seconds without you pressing any key. BIOS will be updated after
the system reboots.
•
You can also press <Y> to force an immediate system reboot to shorten the
process. During system reboot, press the <F11> key to invoke the boot menu
and boot into the build-in UEFI Shell. Your BIOS will be updated automatically.
b. If the FDT is the same
•
BIOS update will be immediately performed without a system reboot initiated.
Warning: Do not shut down or reset the system while updating the BIOS to prevent
possible system boot failure!)
5. Perform an A/C power cycle after the message indicating the BIOS update has
completed.
6. Go to the BIOS setup utility, and restore the BIOS settings.
Question: How do I handle the used battery?
Answer: Please handle used batteries carefully. Do not damage the battery in any
way; a damaged battery may release hazardous materials into the environment.
Do not discard a used battery in the garbage or a public landfill. Please comply
with the regulations set up by your local hazardous waste management agency to
dispose of your used battery properly. Refer to Section 3.3 in this chapter for details.
3-8
Advertisement
Table of Contents
