Advertisement
Attach the fixed wheels to the rear corners
as shown in figure-3. Insert the wheel axle
bolt through the hole in the outer edge of
the corner, the wheel and wheel bearing
support and secure it using a self locking
nut.
Figure-3 Installing the fixed wheel to the
rear corner
Now,
take
a
note
measurement of your machine and add
about 1/2" to it.
Arrange the corners and side rails to
assemble the mobile base the same size as
your machine footprint.
Attach the brackets to the corners and
secure them using two 5/8" bolts and two
small nuts on each connection. Only hand
tighten the nuts for now.
Figure-4 Bracket attached to the corner
of
the
outside
IMPORTANT:
Make sure all the nuts are
on the inside of the mobile base.
Re-check all the dimensions and tighten all
the nuts and bolts.
LOCKING & UNLOCKING
THE CASTOR WHEELS
TO LOCK THE CASTOR WHEELS:
Thread in the knobs until the feet touch the
floor and lift up the caster from the floor,
then tighten the lock nuts.
TO UNLOCK THE CASTOR WHEELS:
Unlock the lock nuts and thread out the
knobs until the caster wheels are touching
the floor and continue until the feet are lift
up.
Figure-5 Foot locking assembly
4
Advertisement
