Table of Contents
Advertisement
3. Connect the cables to the control head.
The slots for the plugs are keyed to
prevent reverse installation, and
insertion should be easy. Do not to force
the connectors into the control head.
4. Pull the power cable through the
opening in the long side of the cable
well and insert it into the battery well
(see the illustration Installing the
Cables Onto the Base).
5. Route the transducer jumper cable (see the illustration Installing the
Cables Onto the Base) out the long side of the cable well and follow the
arrows on the base.
6. Fit the transducer jumper cable connector down into the jumper cable
well and snap it into place. Insert the two #6-32 x 1/4" screws included
to secure the transducer jumper connector and tighten using a Phillips
screwdriver. Hand tighten only!
Installing the Cables Onto the Base
Screws
Power Cable
Connecting the Cables to the Control Head
Transducer
Jumper Cable Well
6
Jumper
Cable
Advertisement
Table of Contents
