3. Using a socket wrench and a Phillips screwdriver, secure the
PiranhaMAX™ mount to the base with the four included 3/4" screws,
lock washers, and nuts. Hand tighten only!
PiranhaMAX™ Mount
(tilt OR tilt and swivel)
4. Install the handle onto the base, so that the curved part of the handle
faces towards the back of the base, towards the battery well. Use the
four included #8-32 x 7/16" screws, two on each side, to attach the
handle to the base (see the illustrations Installing the Handle Onto the
Base and Sliding in the Handle). Hand tighten only!
Installing the Handle Onto the Base
NOTE: The handle is keyed so that it only fits onto the base in one direction.
Attaching the Mount to the Base
3
Sliding in the Handle
Base