Table of Contents
Advertisement
1.
Assembling the PiranhaMAX™ Mount
Your PiranhaMAX™ mount will either have a tilt mount or a tilt and swivel mount.
Refer to either procedures A or B below to assemble the mount.
Tilt and Swivel
PiranhaMAX™ Mount
Countersink
Side Out
Arm Screws,
4 #6 x7/16"
2.
Assembling the Base and Handle
In this procedure, you will install the PiranhaMAX™ mount and handle to the
base of the portable case.
1. Turn the base upside down.
Punch out the mounting holes
labeled "C" with a hammer and
a screwdriver (or an awl) as
shown in the illustration
Punching Holes.
2. Turn the base right side up. Line
up the PiranhaMAX™ mount
with the holes you punched out
in step 1.
A. If you have a tilt mount, refer to the following
information:
No assembly is required for the tilt mount. Proceed
to Assembling the Base and Handle.
Arms
B. If you have a tilt and swivel mount, use the
following steps:
Mount
1. Insert the arms into the mount. Then, hold
the arms in place as you turn the mount
upside down.
Swivel
Ring
2. Insert the swivel ring into the mount, with
the countersink holes for the arm screws
facing out.
3. Secure the arms with the 4 #6 screws
provided. Hand tighten only!
2
Punching Holes
Advertisement
Table of Contents
