Quantum Scalar 50 Upgrade Instructions page 10

Quantum Scalar 50 TC2201 iSCSI Bridge Upgrade Instructions
81-81792-01 A01
July 2007
Figure 10 Cabling a
TC2201 Bridge to the Tape
Drives
10
Installing SCSI Cables with Half-Height Tape Drives
Use the following procedure to connect the SCSI cables and terminators to the
tape drives and TC2201.
• SCSI connectors 0 through 1 on the TC2201 are used to connect to the
system controller board and tape drives 1 through 4.
To cable a TC2201 bridge to the tape drive(s):
1 To connect the SCSI cables from the TC2201 to the tape drives (see
figure 10 and figure
Connect a SCSI cable (VHDC 68-pin to HD 68-pin) from the top port
a
of the system controller board to Port 0 on the TC2201.
b Connect a SCSI cable (VHDC 68-pin to HD 68-pin) from the bottom
port of the system controller board to the upper port of tape drive 1.
c Connect a SCSI cable (HD 68-pin to HD 68-pin) from the bottom port
of tape drive 1 to the top port of tape drive 2.
Install a terminator on the bottom port of tape drive 2.
d
Connect a SCSI cable (VHDC 68-pin to HD 68-pin) from the top port
e
of tape drive 3 to Port 1 on the TC2201.
Connect a SCSI cable (HD 68-pin to HD 68-pin) from the bottom port
f
of tape drive 3 to the top port of tape drive 4.
g Install a terminator on the bottom port of tape drive 4.
Ethernet port
iSCSI ports
SCSI port 0
SCSI port 1
TC2201 Upgrade Procedure
9):
0