Table of Contents
Advertisement
Figure 20 TC2201E
Power Switch and
Connector
Power
Power
connector
switch
Configuring the TC2201E
Configuring the
TC2201E using the
2
Visual Manager
to 90 seconds, during which time the POST and initialization
information may or may not be visible on the terminal or terminal
emulator.
The baud rate used by the terminal or terminal emulator must be
9600, 19200, 38400, 57600, or 115200. The TC2201E will not function
properly at any other baud rate.
Once the POST and firmware initiation processes are complete, the
main menu should be accessible over the serial port. Optionally, the
main menu can also be accessed over the Ethernet port as described
in the next Chapter of this manual.
Reset Button
The TC2201E can be configured in a variety of ways. The following are
general procedures for setting up basic operation. Not all of these settings
will apply to every environment, but these guidelines should provide the
fundamental steps for configuring the TC2201E.
To configure the TC2201E using the visual manager:
1 While DHCP support is enabled by default on the TC2201E, it is
important to ensure that the Ethernet setting for DHCP is set to
Enabled or that a valid IP address and IP gateway have been properly
Quantum TC2201E User's Guide
Chapter 2 Getting Started
Configuring the TC2201E
2
25
Advertisement
Table of Contents
