Table of Contents
Advertisement
Adjusting the Slide
Assembly
Figure 11 Loosening the
Outer Nuts
Now that the slide assembly is installed in the rack, verify that:
‡
10
The front door of the rack opens and closes freely.
‡
The rear door of the rack opens and closes freely.
‡
When fully extended, the slide assembly extends at least 30 in.
(76.2 cm) from the front of the rack.
If the slide assembly and rack do not meet the above requirements,
complete the procedures in this section to adjust the slide assembly.
The number of adjustments required varies from rack to rack.
Adjusting the Slide Assembly on the Mounting Brackets
To adjust the slide assembly on the mounting brackets:
Procedure
Loosen the outer nuts on both sides of the slide assembly (see
1
figure 11).
These nuts secure the mounting brackets to the slide rails.
Move the slide assembly forward or backward as necessary.
2
Installing the Slide Assembly in the Rack
ATL P1000 Series Library Unpacking Instructions
Document 6221100-02, Ver. 2, Rel. 0
Outer nuts
Outer nuts
March 1999
10
17
Advertisement
Table of Contents
