Lowering The Two Rear Rollers; Completing The Move; Fitting The Stability Bracket; Repositioning The Cooker Following Connection - Rangemaster Longstock Deluxe User's Manual & Installation Instructions

90 induction
Table of Contents

Advertisement

Lowering the Two Rear Rollers

To adjust the height of the rear of the cooker, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting nut
(Fig. 8.5).
Rotate the nut – clockwise to raise – counter-clockwise to
lower. Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.

Completing the Move

Unfold the rear edge of the cardboard base tray. Open the
grill door and right-hand oven door so that you can get a
good grip on the bottom of the fascia panel as you move the
oven (Fig. 8.6).
Carefully push the cooker backwards off the base tray.
Remove the base tray.
Position the cooker close to its final position, leaving just
enough space to get behind it (Fig. 8.7).
Do not use the door handles or control knobs to
n
n
manoeuvre the cooker.

Fitting the Stability Bracket

We recommend using a stability bracket; first attach the
bracket location device to the rear of the cooker (Fig. 8.8).
Then adjust the bracket to engage through the slot of the
device (Fig. 8.9 and Fig. Fig. 8.10).
Repositioning the Cooker
Following Connection
If you need to move the cooker once it has been connected,
make sure it is switched off at the supply switch before
gripping under the fascia panel and lifting the front of the
cooker slightly (Fig. 8.6). Check behind the cooker to make
sure that the electricity cable is not caught.
As you progress, always make sure that the cable has
sufficient slack to allow the cooker to move.
When you replace the cooker, check behind it again once
more to make sure that the electricity cable is not caught or
trapped.
INSTALLATION
Check the appliance is electrically safe when you have finished.
ArtNo.010-0004 Moving the cooker
Alternative positions
for stability location
bracket
Stability bracket
Stability
location
bracket
Typical oor mounting
Stability
bracket
Stability
location
bracket
Wall
ArtNo.070-0014 - Stability bracket - Wall fitting
28
Cooker
Floor
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Floor
Fig. 8.5
Fig. 8.6
Fig. 8.7
Fig. 8.8
Fig. 8.9
Fig. 8.10

Advertisement

Table of Contents
loading

Table of Contents