Table of Contents
Advertisement
Make sure that the base of the pan is clean and dry to prevent
any residue burning onto the hob panel. This also helps
prevent scratches and deposits.
Take care when placing hot lids onto the hob
n
n
surface. Lids that have been covering boiling or
steaming foods can 'stick' to the ceramic glass.
Should this occur, DO NOT attempt to lift the lid
off the hotplate: this may damage the hob surface.
Instead, slide the lid to the edge of the hob surface
and remove.
Always use pans that are the same size as (or slightly larger
than) the areas marked on the hob. Using a lid will help the
contents boil more quickly.
Always take care before touching the surface, even
n
n
when the hob is turned off. It may be hotter than you
think!
The induction hob comprises of five cooking zones
containing induction elements with different ratings and
diameters (Fig. 2.4) each with a pan detector and residual
heat indicator, and a hob control display.
The hob control display (Fig. 2.5) informs you of the following
induction hob functions:
•
Pan detector
• H Residual heat indicator
•
Child lock
• L1/L2/L3 Low temperature setting
• P Power boost setting
Pan Detector,
IMPORTANT: After use, switch off the hob element
n
n
by its control and DO NOT RELY on the pan detector.
If a cooking area is switched on and there is no pan in place
or if the pan is too small for the cooking area, then no heat
will be generated. The symbol [ ] will appear on the hob
control display; this is the "pan-missing symbol". Place a pan
of the correct size on the cooking area and the [ ] symbol
will disappear and cooking can begin. After 10 minutes
without detecting a pan the cooking zone will switch off
automatically.
Table 2.1 shows the minimum pan sizes recommended for
each cooking zone.
Note: Using pans with a base diameter smaller than those
recommended will result in a power reduction.
Residual Heat Indicator, H
After use, a cooking zone will remain hot for a while as heat
dissipates. When a cooking zone is switched off the residual
heat indicator symbol [H ], will appear in the display. This
shows that the cooking zone temperature is above 60 °C and
may still cause burns. Once the temperature has dropped to
below 60 °C the [H ] will go out.
Max: 1.85 kW
Boost: 2.5 kW
Zone 2
Zone 1
Max: 1.85 kW
Boost: 2.5 kW
Cooking Zone
Front left
Rear left
Centre
Rear right
Front right
7
Max: 1.85 kW
Max: 1.85 kW
Boost: 3.2 kW
Boost: 2.5 kW
Zone 4
Zone 3
Zone 5
Max: 1.15 kW
Boost: 2.0 kW
Minimum Pan Diameter
(Pan Base) mm
180
180
210
180
140
Table 2.1
Fig. 2.4
Fig. 2.5
Advertisement
Table of Contents
