Table of Contents
Advertisement
5
Fit the backplate to the wall in the orientation shown using the fixing screws (supplied).
Tighten by hand, do not over tighten.
6
Connect the cable on the back of the controller to the cable that comes from the valve.
7
Locate the top of the controller in the backplate and press down on the bottom button
as you install in position.
To remove the controller, place a 1.5mm Allen key (supplied) or small flat blade
screwdriver into the hole on the bottom of the user interface, press upwards, pivot the
controller up from the bottom and lift it off to remove it from the wall mount.
45
Advertisement
Table of Contents
