Table of Contents
Advertisement
Push fit the water supply pipe to the bath filler using copper pipework (15mm diameter).
5
Note: Make sure that the pipe is pushed in fully (min 30mm) until it hits the
internal stop feature.
Important! Cut the pipe using a pipe cutter only to ensure the seals are not
damaged when the pipe is inserted. Remove all burrs.
Insert the locking clips (supplied) to secure the pipe in place.
Insert Locking Clip here
6
Turn on the water supply and check for leaks from the waste and the bath filler
connections.
page 49 for pumped product.
42
Refer to 'Commissioning'. See page 46 for high pressure product,
Locking Clip
Advertisement
Table of Contents
