HP Z1 Entry Tower G5 Maintenance And Service Manual page 51

6. To remove an M.2 SSD card, remove the screw that secures the card (1), lift the end of the card up (2),
and then slide the card out of the system board connector (3).
7. To install an M.2 SSD card, slide the pins on the card into the system board connector while holding the
card at approximately a 30° angle (1). Press the other end of the card down (2), and then secure the card
with the screw (3).
8. Rotate the drive cage down (see
9. Connect the power and data cables to the rear of the drives in the hard drive cage.
10. Reassemble the computer.
Drive cage on page 27)
Drives 43