Card Reader - HP Z1 Entry Tower G5 Maintenance And Service Manual

Card reader

The card reader is secured to the front of the chassis under the front bezel.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Disconnect the power and data cables from the rear of the drives in the drive cage.
5. Rotate the drive cage up (see
6. Disconnect the cable (1) from the system board connector, and then remove the cable from the clip (2).
7. Remove the Torx screw that secures the card reader to the front of the chassis (3), and then pull the card
reader away from the front of the chassis (4).
To install the card reader, reverse the removal procedure.
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 19).
Drive cage on page
18).
27)
17).
Card reader 61