Tandberg Data SuperLoader Quick Start Manual page 2

This guide contains
a sequence of steps
recommended for
unpacking, installing,
and setting up your
autoloader.
For additional information:
Refer to the enclosed CD-ROM,
visit www.tandberg.com
2
1
Unpack the
autoloader
Tandberg Data recommends that two
people unpack the autoloader and that
you practice good ergonomic techniques
to lessen the risk of personal injury and
damage to the unit.
Look for markings on the carton that indi-
a
cate the top. If necessary, re-position the
carton so that it is upright according to
the markings.
Use a utility knife or scissors to cut the
b
packing tape along the length and ends
of the carton.
c
Remove the accessories box from the car-
ton. The accessories box contains the fol-
lowing items:
• Cable(s)
• Documentation CD
• Mounting hardware (brackets and
screws)
• Power cord
• Quick Start Guide
d
Each unpacker should:
1. Position him/herself along a length-
wise side of the carton, facing the
other unpacker.
2. Reach in through the openings in
the foam packaging and grip the
autoloader securely.
3. In a coordinated motion with the
other unpacker, lift the autoloader
out of the box and place it on a flat,
stable surface.
e
While one unpacker steadies one side
of the autoloader, the other unpacker
should grip the front of the autoloader
with one hand and remove the foam
packaging from the other side of the
unit.
!
Caution
Do not rest the autoloader on the
unpacked side. The weight of the unit
could bend the metal flange on the
front end.
While one unpacker steadies the
f
autoloader, the other unpacker should
remove the foam packaging from the
other side of the unit and set down the
unit.
g
Remove the foam inserts from the front
of the unit.
3