Tandberg Data SuperLoader Quick Start Manual page 11

This section explains
how to correctly
handle magazines
and cartridges.
20
Use magazines
and magazine
blanks
The Autoloader will not run unless both
magazine openings are properly closed.
One way that you can close the openings
is to use two magazines. If you use only
one magazine, then you must fill the
other magazine opening with a magazine
blank for the unit to become operational.
For instructions about how to
assemble a magazine blank, provid-
ed the one you received is not
assembled, see the User Manual.
Eject a magazine
When you want to remove several
cartridges at once, eject the magazine(s)
first.
a On the LCD, press Enter and then scroll to
Commands. Press Enter again to select
Commands.
Scroll to Eject and press Enter.
b
c
Scroll to Right Magazine or Left
Magazine and press Enter to eject that
magazine.
If the front panel requests a password,
the default password is 000000. If you
are using the Web Administration, the
default passwords are
Username = guest
password = guest
The magazine selected will be released
and can be removed.
! Caution
To prevent damage to the autoloader or
the magazine, use both hands when
removing the magazine from the
autoloader, supporting the entire length
of the magazine.
Grasp the magazine by the handle with
d
one hand and slide it out, supporting it
underneath with the other hand.
Note: When you eject a magazine, you
must fully remove it or fully re-install it
before powering off the autoloader.
21