Select Serif Or Sans Serif Font; Select User-Defined Font; Select Vertical Tab Channel - Printronix P5000LJ Series Programmer's Reference Manual

Chapter 5
Configuring the Epson FX-1050 Emulation with Control Codes

Select Serif or Sans Serif Font

ASCII Code ESC k n
Hex Code
Dec Code
†Purpose
where

Select User-Defined Font

ASCII Code ESC % n
Hex Code
Dec Code
Purpose
†Discussion The printer ignores this command and removes all font data

Select Vertical Tab Channel

ASCII Code ESC / c
Hex Code
Dec Code
Purpose
where
Discussion Subsequent VT (Hex 0B) commands use tab table specified by
184
1B 6B n
27 107 n
Selects an NLQ font.
n may range from 0 through 255 (hex 00 through hex FF).
n = 0, 2, 4 .. (any even value), the font selected is a serif NLQ
font (Courier, instead of standard Epson Roman).
n = 1, 3, 5 .. (any odd value), the font selected is a sans serif
NLQ font.
1B 25 n
27 37 n
Selects a user-defined font.
sent from the data stream.
1B 2F c
27 47 c
Selects a vertical tab channel set by ESC b.
c = 0 through 7.
c . If no tab table is selected, channel 0 is used.