Line Spacing 1/6 Inch (6 Lpi); Line Spacing 1/8 Inch (8 Lpi) - Printronix P5000LJ Series Programmer's Reference Manual

Chapter 3
Configuring the P-Series Emulation with Control Codes

Line Spacing 1/6 Inch (6 lpi)

ASCII Code SFCC 2
Hex Code
Dec Code
Purpose
Discussion For SFCC LPI; n , the value of n can be 6 or 8 only. If n = 6, this
Example

Line Spacing 1/8 Inch (8 lpi)

ASCII Code SFCC 0
Hex Code
Dec Code
Purpose
Discussion When the 1/8-inch line spacing control code is received, all lines
Example
94
SFCC LPI; n
SFCC 32
SFCC 50
Sets line spacing to 6 lpi or as set by SFCC A (page 96).
command sets line spacing to 1/6 inch. Values of n other than 6
or 8 will cause an error message.
SFCC 2 asserts n /72-inch line spacing as set by SFCC A (page
96). If no distance has been set by SFCC A, the distance is 1/6"
The control code line spacing selection will override the control
panel line spacing setting.
The following example illustrates 1/6-inch line spacing and
assumes that a distance has not been set by ESC A.
SFCC LPI; n
SFCC 30
SFCC 48
Specifies continuous line spacing at 1/8-inch increments (8 lpi).
will be printed at 8 lpi until a new line spacing is selected or the
printer is reset. The control code line spacing selection will
override the control panel line spacing setting.
For SFCC LPI; n , the value of n can be 6 or 8 only. If n = 8, this
command sets line spacing to 1/8 inch. Values of n other than 6
or 8 will cause an error message.
The following example illustrates 1/8-inch line spacing.