Control Panel; How To Use - Wilfa PF-1200S Operating Instructions Manual

8

Control Panel

Pre-set program
Icons
Pulse
button
On/OFF
Button
Indicator lamp

How to Use

Check that the electrical rating shown on the rating plate corresponds with
your household electricity supply.
„ Stand-by mode and energy saving mode
Plug in the blender and set the blender jug on the base unit. The power
light and indicator lamp will light up in red; the blender is now in stand-
by mode.
If the blender is left idle for 3 minutes the blender will go into energy
saving mode; the power light will remain lit with a red light, while the
indicator lamp will go out. (From energy saving mode, the unit will go
into stand-by mode when any key is pressed)
„ ON/OFF button
This button is the ON/OFF key for the pre-set programs. A selected
pre-set program function will only be activated by pressing the ON/OFF
button. Pressing the ON/OFF button again will stop the unit.
„ PULSE button
„ Speed Settings
Speed dial
„ Preset Program Key
Power light
This is the manual button for PULSE operation.
In stand-by mode, with the speed dial pointing to the OFF position,
hold the PULSE button down and the motor will increase to full speed in
PULSE mode, and the indicator lamp will show a white light. It will stop
when PULSE is pressed again, and the blender will return to Stand-by
Mode.
This blender has 10 continuously variable speed settings. In stand-by
mode, turn the speed dial clockwise from the OFF position, and the
blender will operate at the corresponding speed. By continuing to
turn the speed dial clockwise, the speed will gradually increase, finally
achieving maximum speed. During operation, the work indicator lamp
will turn white. The blender will automatically turn off after 10 minutes.
To reset the blender for the next operation, turn the speed dial back to
the OFF position.
Icon Function
Increases to Speed 7 in 7 sec, then
increases to Speed H in 3 sec, and
Soup keeps at this speed until finish.
Total duration is 8 minutes.
Every start-up is soft-start.
Speed H 30s, stop 2s;
Speed 6 10s, stop 2s;
Speed H 60s, stop 2s;
Vegetables
Speed 6 10s, finish;
Total operation is 1m 56s.
Every start-up is soft-start.
Soft start to Speed H for 8s, and
stop for 2s. Repeats the cycle until
Smoothie
the total operation time is 30s.
Every start-up is soft-start.
To use the preset programs, the blender should first be in Stand-By
Mode, then select and rotate the Speed Dial from the OFF position to
the desired preset program setting and when finished press the ON/OFF
button.
To stop the blender during operation of one of the programs, press
the ON/OFF button to stop the blender. After operation of the preset
program, the blender reverts to stand-by mode.
Operation Cycle
9