Control Panel; How To Use - Wilfa BPF-1200S Operating Instructions Manual

8

Control Panel

Pre-set program
Icons
Pulse
button
On/OFF
Button

How to Use

Check that the electrical rating shown on the rating plate corresponds with
your household electricity supply.
„ Stand-by mode and energy saving mode
Plug in the blender and set the blender jug on the base unit. The power
light and indicator lamp will light up in red; the blender is now in stand-
by mode.
If the blender is left idle for 3 minutes the blender will go into energy
saving mode; the power light will remain lit with a red light, while the
indicator lamp will go out. (From energy saving mode, the unit will go
into stand-by mode when any key is pressed)
„ ON/OFF button
This button is the ON/OFF key for the pre-set programs. A selected
pre-set program function will only be activated by pressing the ON/OFF
button. Pressing the ON/OFF button again will stop the unit.
Indicator lamp
Speed dial
Power light