Control Panel - Wilfa Power Crush PB-1600S Operating Instructions Manual

9

Control panel

ON/OFF switch
To use the appliance, you must first turn the on/off switch to the on position (Pos. I).
You can then select automatic programs, use the pulse function or the speed
controller.
Speed controller
You can use the speed controller to infinitely adjust the speed of the high
performance motor between min and max.
For this, switch the appliance on using the on/off button (Pos. I) and select the
desired speed with the speed regulator.
When you have finished blending, turn the speed controller back to the initial
position (see image) and then switch the on/off button off again (Pos. O).
Pulse function
The motor runs at maximum speed as long as the PULSE button is held down.
This is particularly useful for a final mix before pouring.
Preset program buttons
In order to carry out common tasks with the Smoothie Blender, the appliance has
three automatic programs for smoothies, sauces and frozen foods.
Smoothie
The Smoothie button can be used for preparing smoothies easily. Switch on the
appliance using the On/Off button (Pos. I). Now press the Smoothie button,
the blender will run a program with different speeds. The program will stop
automatically after approximately 26 seconds. You can stop the program at any time
by pressing the Smoothie button again or moving the on/off switch to off (Pos. O).
Ice cream
You can use the Ice cream button for crushing frozen foods. This is suitable when
preparing ice cream, sorbets and frozen smoothies. Switch on the appliance using
the On/Off button (Pos. I). Press the Ice cream button, the blender will start an
automatic program with different speeds.
The program ends automatically after approximately 26 seconds. You can stop the
program at any time by pressing the Ice cream button again or moving the on/off
switch to off (Pos. O).
Sauce
The Sauce button can be used for preparing sauces easily. Switch on the appliance
using the On/Off button (Pos. I). Press the Sauce button, the blender will start an
automatic program with different speeds.