Printronix P7000 Programmer's Reference Manual page 20

Chapter 1
Installing Printer Emulations
Message
ERROR: PROGRAM NEEDS
MORE FLASH
ERROR: PROGRAM NOT
COMPATIBLE
ERROR: PROGRAM NOT
VALID
ERROR: SECURITY PAL
NOT DETECTED
ERROR: SHORT AT
ADDRESS XXXX
ERROR: WRITING TO
FLASH
ERROR: WRONG
CHECKSUM
ERROR OCCURRED
FLUSHING QUEUES *
LOADING PROGRAM FROM
PORT XX %
20
Explanation
The printer requires more
flash memory in order to run
the downloaded program.
The printer is not compatible
with the downloaded
program.
The printer does not see a
program in flash memory.
The security PAL is not
present or has failed.
Hardware failure in DRAM or
CMX controller circuitry.
Hardware or software fault in
flash memory.
The printer received the
complete program but the
checksum did not match. The
data were corrupted during
download.
This is an interim message
that displays while the printer
discards host data it cannot
use because a fault condition
exists. While this message
displays, the asterisk (*)
rotates.
The new program is loading
into printer RAM. XX
indicates how much of the
program has loaded.
Required Action
Add flash memory or use a
smaller emulation program.
Use the correct emulation
software option(s) for this
model.
There is no program in printer
memory. Download the
program again.
Check the security PAL at
location U54 on the CMX
controller. If the PAL is
absent, install correct PAL. If
security PAL is present,
replace the CMX controller
board.
Replace DRAM. If message
occurs with new DRAM,
replace CMX controller board.
1. Download the program
again.
2. If the message occurs
again, replace the flash
memory.
Download the program again.
Wait. When the asterisk (*)
stops rotating, a different fault
message will appear:
troubleshoot the final
message.
None