Initialize The Developer Unit - Printronix L7032 Quick Setup Manual

Initialize the Developer Unit

CAUTION
You must initialize the developer unit, or the printer will not
apply toner properly. If this happens, you must remove the
developer mix from the developer unit and replace it with new
mix.
1. Plug in the printer's power cord.
2. Use the on/off switch to turn the printer on.
3. Press the MENU button to enter the menu system. The LCD
will display
MAIN MENU
CONFIGURATIONS
4. Press
MAIN MENU
CONSUMABLES on the display.
5. Press
6. Press
CONSUMABLES
INIT DEVELOPER on the display.
7. Press SHIFT +
8. Use
>
Initializing the developer unit takes about 190 seconds (a little
more than 3 minutes).
9. When you see the "DEVELOPER INITIALIZED" message,
press SHIFT +
"Off line" appears on the status display.
10. Use the on/off switch to turn the printer off.
;
<
(left arrow) or (right arrow) until you see
>
(down arrow) to select the CONSUMABLES menu.
;
<
(left arrow) or (right arrow) until you see
>
to select.
;
<
or to select No or Yes to continue, then use SHIFT +
to begin the initialization.
=
to exit the menu system.
31