Table of Contents
Advertisement
Install the Developer Mix
10. As you move the new developer unit into the printer, make sure
that the semi-circular metal piece on the lower right side of the
developer unit fits over the black plastic guide, which is
connected to the latch. See Figure 22. To avoid catching the
developer unit on the upper part of the printer, you may need to
angle the developer unit down slightly as you move it into the
printer.
Figure 22. Putting the Developer Unit in the Printer
11. After the new developer unit is on the black plastic guide and
has cleared the upper part of the printer, push it all the way into
the printer. The developer unit will not lock into place until you
close the latch.
28
Advertisement
Table of Contents
