Primera Max User Manual page 31

TOC INDEX
Test recording performs all of the operations of recording with
the drive's laser turned on to reading power. A test recording
run will determine if the data source will keep up with the
recorder's demand. Normally, a single test run is sufficient to
determine if a condition knows as "buffer underrun" will occur.
If a buffer underrun occurs during recording, all the discs that
are run through your CD Recorder will be wasted! So, a quick
test recording is highly recommended before starting a job and
walking away.
Verifying will test the CD-R disc itself to make sure that it is
capable of receiving data. Discs that do not pass verification
will be rejected before recording begins, thus saving valuable
recording time.
After your job(s) have been set up, each one may be started by
clicking on the red "Record" button at the top of the Job Setup
Panel. Here's what the Job Setup Panel looks like:
Pause Button
Record Button
Stop Button
While jobs are running, they may be paused or stopped by
clicking on the appropriate buttons on the Job Setup Panel.
The Pause Button will allow the current recording to finish,
then suspends operations on that job. Recording is resumed by
clicking the Pause Button again.
Running Your First Job 27