Fine Tuning The Printer Stand Alignment - Primera Max User Manual

TOC
Check one more time for printer alignment by pressing after
the screws have been tightened down, just in case something
changed while you were making the adjustment. Re-align if
necessary.
l. Press the
m. Press the
Output
n. Press the Pick button again. The CD will be picked up
out of the Output Bin.
o. Press the Sequence button several times until the CD is
transported back above the Input Bin.
p. Press the Pick button. The CD will drop into the
C. FINE TUNING THE PRINTER STAND ALIGNMENT
If you find that some discs are not being held tightly in the
printer tray and start to move inside the printer while printing,
the printer stand may need further alignment. If the discs are
not placed in the exact center of the Printer Tray, it is possible
you will encounter failed picks or poor print quality. There is a
special Fine Tune Alignment built in to the program of the
Duplicator to ensure proper picks. To perform this alignment,
follow these steps:
1. Open the Printer Tray by pressing the Printer Tray Button
on the top of the Printer Control Panel.
2. Loosen the three Printer Stand Adjustment Screws shown.
Press and hold the Sequence and Pick Buttons on the front
of the Duplicator until the Robotic Arm is positioned over
the Input Bin.
3. Press and hold the Pick Button on the Duplicator's Front
Control Panel for 5 seconds. Your will see the LEDs on the
front of the Duplicator toggle back and forth.
4. Immediately press the Pause Button, then press the
Sequence Button to enter Fine Tune mode. (If using the
thermal printer, press the Pause Button twice to enter Fine
Tune mode.)
5. Next, press the Duplicator's Pick Button to perform the
Printer Tray Fine Tune Alignment. The Robotic Arm will
move to the printer position and hover just above the
Printer Tray.
18 Hardware and Software Set-Up and Testing
Sequence button.
Pick button. The CD will drop into the
Bin.
INDEX
Input Bin.