Software Installation - Primera Max User Manual

TOC
6. With the Robotic Arm holding a disc just over the tray,
move the printer around until aligned as close as possible.
For a more accurate alignment, press the Sequence Button
to step the arm slightly to the right (clockwise), or press
the Pause Button to step the arm slightly to the left
(counter-clockwise).
7. With the printer aligned, tighten the three Printer Stand
Adjustment Screws.
8. Press the Pick Button to exit the
9. Test your alignment by pressing the Pick Button repeatedly
to pick and place a disc into the tray.
You have now completed the Hardware Test and Printer
Alignment. Continue on to the Software Installation.
D.

SOFTWARE INSTALLATION

Once you have properly set up your Duplicator and optional
CD printer, the next step is to install the appropriate software
on your PC that you'll need for duplicating and printing.
There are two software programs to install: (1) the
driver software, and (2) the CD duplicating application
software called PrimoDVD. Install one or both of the software
programs as follows:
1. Install the printer driver software according to the
instructions in that unit's Operator's Manual.
2. Install PrimoDVD software as follows:
a. Close down all other software applications.
b. Insert the included CD into your computer's CD-ROM
c.
d. Double-click on the icon for the CD drive containing
e.
drive. In most computers the software will auto-boot.
If it does, proceed to Step 3 below. If it does not,
follow these steps:
Double-click the My Computer Icon.
the PrimoDVD software disc.
Double-click on the Autorun.exe file to start the
installation.
Hardware and Software Set-Up and Testing 19
INDEX
Fine Tune Mode.
printer