Section 2: Hardware And Software Set-Up And Testing; Connecting Interface Cables - Primera Max User Manual

TOC
Section 2:
A. CONNECTING
1. Make sure that your PC is turned off and that it is
disconnected from its power source. Leave the PC turned
off until you are requested to turn it on later in this set-up
procedure.
2. Install a compatible
refer to the board manufacturer's instructions for the
proper installation procedure.
3. Connect the
FireWire port
other end is connected to the FireWire board's output port
on your PC.
10 Hardware and Software Set-Up and Testing
Hardware and Software
Set-Up and Testing
INTERFACE CABLES
FireWire board
FireWire cable. One end is connected to the
on the rear panel of the Duplicator. The
INDEX
inside your PC. Please