Advertisement
explained within the Cartridge button description of
section 3-D in the manual to clean the cartridge nozzles.
Also, you must perform a bidirectional calibration prior to
printing; see the description in Section 3-D after you have
installed the printer driver.
6.
Connect the printer to your computer using the proper
interface cable. For best results, use a IEEE 1284-Compliant
cable and do not connect to an A/B switch box. Also, note
that the printer will print fastest if your computer's
parallel port is set to ECP mode (most new computers are
set to ECP). Your computer's manual will have information
on changing the parallel port mode if you need to switch it
to ECP .
SOFTWARE INSTALLATION
Once you have set up your printer, you must then install all of
the appropriate software required for printing. The included
CD contains all of the necessary software. At a minimum, you
must install the printer driver appropriate for your computer's
specific operation system (Windows
2000/XP). Below is a description of the CD contents as well as
installation instructions for each software component.
CD Contents:
•
CD Color Printer Pro Driver for Windows 95/98/Me
•
CD Color Printer Pro Driver for Windows 2000/XP
•
32-Bit Print Spooler for Windows 95/98/Me (provides
optimum print processing under Windows 95/98/Me)
•
2 Sample CD Designs (TIFF format)
Installation Instructions:
Windows 95/98/Me or Windows 2000/XP Printer Drivers:
1.
Insert the included CD into your computer's CD-ROM
drive.
2.
Click on the Start button on the task bar, point to Settings,
and select Printers.
3.
Double-click on the Add Printer icon. This will launch the
Add Printer Wizard. Click Next, then click Next again.
4.
Click the Have Disk button.
iv
95/98/Me or Windows
®
Advertisement
