Table of Contents
Advertisement
Quick Links
ATLANTA
DECORATIVE RADIANT
NATURAL VENT GAS FIRE
User Instructions
These instructions should be read by the user before operating the appliance and retained
for future reference
Model no. FAVR**MN is only for use on Natural Gas (G20) at a supply pressure of 20 mbar in
G.B. & I.E.
** denotes trim & fret variant
Advertisement
Table of Contents
Related Manuals for Flavel Atlanta
Summary of Contents for Flavel Atlanta
- Page 1 ATLANTA DECORATIVE RADIANT NATURAL VENT GAS FIRE User Instructions These instructions should be read by the user before operating the appliance and retained for future reference Model no. FAVR**MN is only for use on Natural Gas (G20) at a supply pressure of 20 mbar in G.B.
-
Page 2: Installation Information
INSTALLATION INFORMATION CONDITIONS OF INSTALLATION It is the law that all gas appliances are installed only by a competent (e.g. CORGI Registered) Installer, in accordance with the installation instructions and the Gas Safety (Installation and Use) Regulations 1998 as amended. Failure to install appliances correctly could lead to prosecution. It is in your own interest and that of safety to comply with the law. - Page 3 ABOUT YOUR NEW ATLANTA FIRE The Flavel Atlanta vented gas fire incorporates a unique and highly effective fuel bed, which gives a modern and stylish flame appearance. The fuel bed is produced from a ceramic fibre shaped to increase radiant heat and efficiency.
-
Page 4: Important Safety Information
Servicing should be carried out annually by a competent person such as a CORGI registered engineer. It is a condition of Flavel guarantees that this is carried out by a competent person i.e a CORGI registered Engineer in accordance with these servicing notes We recommend that during the annual service, replacement of the pilot is carried out. -
Page 5: Operating The Fire
OPERATING THE FIRE The controls are located behind the ashpan cover below the fender. The controls, comprise a control valve to adjust the gas flow and a push button piezo igniter. To light the fire proceed as follows:- 1) Depress the control knob and turn anti-clockwise to the position marked pilot. - Page 6 CLEANING WARNING Before attempting any cleaning operation ensure that the fire has been allowed to fully cool. CLEANING THE STAINLESS AND PAINTED METAL PARTS. The trim fitted to this appliance is stainless steel, and must only be cleaned with a clean, damp cloth.
-
Page 7: Removing & Refitting Of The Glass Frame
REMOVING & REFITTING OF THE GLASS FRAME Top infill panel. 4 Allen key fixing screws Storage of Allen Remove the contemporary trim & ashpan cover from the firebox. Remove the pilot heat shield, which is held in place at each end by 1 screw. Remove the top infill panel by sliding it upward out of the clips. -
Page 8: User-Replaceable Parts
USER REPLACEABLE PARTS There are no user replacement parts. Replacement of any parts must be carried out by a competent person such as a CORGI registered gas installer. Note. The rating plate is positioned at the bottom right hand side of the firebox. Due to our policy of continual improvement and development the exact accuracy of descriptions and illustrations cannot be guaranteed Part No.