Section 3: Using The Cd Color Printer Pro With Windows; Connecting The Printer To Your Computer - Primera Signature Pro User Manual

TOC
Section 3: Using the CD Color
A. CONNECTING THE PRINTER TO YOUR COMPUTER
The CD Color Printer Pro is designed to be used with nearly
any IBM-PC
The printer is equipped with a standard 8-bit Centronics-type
parallel
data from your computer. To connect the printer to your
computer, obtain a shielded, bi-directional parallel cable, and
refer to the following steps:
NOTE: It is highly recommended you use a fully shielded IEEE 1284
compliant parallel cable under 10 feet in length. For faster
printing, your computer's parallel port mode should be set to ECP.
If you experience problems with this setting or if your computer's
parallel port is not ECP compatible, set your computer's parallel port
to the standard output only "Printer Port" setting. Refer to your
computer's system documentation for instructions on checking and/or
changing the parallel port mode.
1. Connect the Centronics-type parallel side of the cable to the
printer. Snap the fastening clips into place.
2. Connect the other side to the back of your computer at
LPT1, LPT2, or the PARALLEL connector.
Printer Pro with Windows
or compatible running Windows 2000/XP .
®
port. This port is the means through which it receives
Using the CD Color Printer Pro with Windows 11
INDEX