Read Me First - Primera Signature Pro User Manual

Read Me First!

Congratulations on the purchase of your new CD Color Printer. To
begin printing with your new printer immediately, please refer to the
following quick start instructions. For more complete information
regarding all aspects of your printer's operation, please refer to the
printer's main User's Manual.
HARDWARE SETUP
1. Unpackage your printer, and check that the following
items are included:
•
•
•
•
•
•
•
•
2. Connect your printer's power.
3. Open the front cover and install the included color and
black ink cartridges by pressing the
Button. The color cartridge must be installed in the left
position and the black cartridge must be installed in the
right position. Insert the cartridges copper-end first into the
ink cartridge carrier. Then, push the top of the cartridge
back until it snaps into place. When both cartridges are in
place, press the
cartridge carrier.
4. Press the
cardboard CD templates into the CD Tray.
5. Run a self test according to the instructions in Section 2-D
of the printer User's Manual. This will ensure that both the
printer and the ink cartridges are functioning properly.
This procedure should also be done whenever you install
a new ink cartridge or if your printer has sat for a few
days without printing. If some of the nozzles do not seem
to be firing, perform a clean operation after the printer
Power Adapter
Separate Power Cord (220-240V units only)
Printer Software CD
Color Ink Cartridge
Black Ink Cartridge
Cardboard CD Templates (5)
Warranty Statement and Registration Card
Operator's Manual and Other Printed Information
CD Tray Button, and install one of the
Ink Cartridge Button again to reset the
Ink Cartridge
iii