Table of Contents
Advertisement
3.4 Battery Removal and Installation
Battery Removal
To remove the external CMOS battery, follow the steps below:
1. Power off your system and unplug your power cable.
2. Remove the battery cable at the BT1 connector on the board.
3. Remove the battery.
Proper Battery Disposal
Handle used batteries carefully. Do not damage the battery in any way; a damaged battery
may release hazardous materials into the environment. Do not discard a used battery in the
garbage or a public landfill. Comply with the regulations set up by your local hazardous waste
management agency to dispose of your used battery properly.
Battery Installation
1. Unplug the power cord.
2. Connect the battery cable into the battery connector (BT1) and push it down until you
hear a click to ensure that the cable is securely locked.
3. Use the foam tape on the back side of the battery to secure the battery to a flat surface
on the bottom of the motherboard or proper location in the system. DO NOT place the
battery on the heat sink.
Chapter 3: Troubleshooting
59
Advertisement
Table of Contents
