Checks After Installation - Panasonic MicroClear TK-CS200 Operating Instructions Manual

Installation 5
1
Run purified water for about 5 minutes to expel the air inside the main
unit.
① Set the bypass selector to "
② Turn on the water faucet to let the water flow.
Note
Purified water may contain some black powder (activated carbon).
z
The amount will decrease as more water flows, so continue checking the water condition for
a while.
2
Check the items on P. EN10-EN11 for any malfunctions.
Check item
Is water coming out of the
main spout?
Main spout
Is any water leaking from
where the bypass selector
is connected?
Is there any water leaking
from where the hose is
connected?
EN10
TK-CS200_01_EN.indd TK-CS200_01_EN.indd 9 9

Checks after installation

".
Trouble inspection location and remedial action
Is the hose bent or flattened?
z
→ If it is, straighten it out.
Has the bypass selector been installed
z
securely on the faucet?
→ Check again the instructions for "Attaching the
bypass selector ", and install it securely.
Have the parts inside the bypass selector been
z
Inserted properly?
→ If not, install them properly.
Are there any cracks at the end of the faucet
z
(in the insulating cap, for instance)?
→ Consult a plumber.
Has the hose been attached securely to the
z
bypass selector?
→ Insert it as far as it will go, and use the hose
fastening nut to secure it.
< OK >
Reference
EN7-EN8
EN7-EN8
< NG >
Gap
2022/12/15 2022/12/15
page
EN9
―
EN9
18:41:42 18:41:42