Replacing The Cartridge; When The Water Supply Is Cut Off; When Not In Use For A Long Time - Panasonic MicroClear TK-CS200 Operating Instructions Manual

Replacing the Cartridge

4
Attach the cover.
① Tighten the cover.
y Until there is no more gap between
cover and case
< OK >
y Until the outlet
pipe connector
aligns with the case
projection
② Attach the outlet pipe (P. EN9).
5
Affix the cartridge replacement label.
Write the date of replacement on the
z
label included with the new cartridge.
(P. EN9)

When the water supply is cut off

The Water Purifier cannot be used. If the water is cut off during use, turn off the faucet.
z
When the water supply is restored, set the bypass selector to "
z
into the sink to run out the air and turbid water inside the pipes.
The Water Purifier may then be used again as usual.
(This is because the cartridge life will be significantly reduced.)

When not in use for a long time

When not used for about 1 week or longer
„
Remove the cartridge (P. EN14-EN15), and store it sealed
z
in a vinyl bag in a refrigerator.
y Remove air from the bag, and close the opening.
Note
Storing the cartridge for a prolonged period may alter the quality of the water within the cartridge,
z
so replacing the cartridge is recommended.
To use this unit again
„
① Install the cartridge (P. EN14-EN15)
②
Run water for about 3 minutes, and check before using that there is no water leak.
TK-CS200_01_EN.indd TK-CS200_01_EN.indd 14 14
① ●
< NG >
Gap
(continued)
6
Open the faucet, and
run purified water through the
Water Purifier.
(for about 5 minutes)
Note
Purified water may contain some black
z
powder (activated carbon).
The amount will decrease as more water
flows, so continue checking the water
condition for a while.
" and first run tap water
EN15
2022/12/15 2022/12/15 18:41:44 18:41:44