Panasonic MicroClear TK-CS200 Operating Instructions Manual page 8

Installation 3
y Water faucet which can attach the bypass selector with accessory.
①
1
Remove the nut and adaptor.
Do not remove the gasket and the filter inside the bypass selector.
If these are moved, return to the original position.
Make sure foreign matter is not attached to the filter and the gasket
is not inclined.
2
Insert the installation adaptor,
and tighten it with the nut.
Remove the screws
(4 pcs.)
Installation adaptor
(Accessory)
3
Tighten the 4 screws
temporarily and loosen the nut
to leave a 3 - 4 mm gap.
3 - 4 mm
EN8
TK-CS200_01_EN.indd TK-CS200_01_EN.indd 7 7
Attaching the bypass selector
Faucet without an aerator
Bulge
①
②
②
Gasket and Filter
① 11 mm or more
②
13 mm or more, less than 24 mm
4
Push the bypass selector
against the faucet and install
the 4 screws as shown below.
Water faucet
Top view
z
< OK > < NG >
①
② ③
5
Tighten the nut until the bypass
selector does not turn.
Do not use any tools. (This may
z
damage the nut.)
Make sure the bypass selector is
z
not inclined.
(continued)
Nut
Adaptor
(with gasket)
Gasket
Bypass
selector
① Water faucet
② Installation adaptor
③ Screws
2022/12/15 2022/12/15 18:41:41 18:41:41