JRC JMA-5204 Instruction Manual page 272

[I] Method of Displaying Target Data [TGT DATA]
Procedure 1
[II] Canceling numerical data display (CNCL Data)
Procedure 1
Move the cross cursor mark onto the target for which numeric data is to
be displayed, and press the [TGT DATA] key.
Or, set the cursor mode to TGT Data, place the cross cursor over the
target whose numerical data is to be displayed, and press the [ENT] key.
Then, the data of the designated target will appear, it will be marked with a symbol "
The target data will remain on the radar display until the target is lost and its vector
disappears, or until another target is designated.
If a target with the mark "
(RANGE) will appear until its vector appears.
Set the cursor mode to TGT Data, place the cross cursor over the tracked
target whose numerical data is to be displayed, and press the [CLR/INFO]
key.
Numerical data display is canceled.
" is designated, only its true bearing (BEARING) and range
23
".