JRC JMA-5204 Instruction Manual page 152

[II] Using Multi-function Control
Procedure 1
2
* Software button
available for switching the settings.
Press the [MULTI] control to select the parameter whose setting is to be
changed.
Parameters will be selected sequentially each time the [MULTI] control is pressed.
The currently selected parameter is indicated at the lower left of the radar display.
For example, if three parameter 1-3 are initially set to
following sequence each time the [MULTI] control is pressed:
MULTI (VECTOR)
Press the [MULTI] control.
MULTI (TRAILS)
Press the [MULTI] control.
MULTI (TGT No.)
Press the [MULTI] control.
Turn the [MULTI] control to change the setting.
The preset values of the selected parameter will change sequentially.
Stop turning the control when the desired value appears.
located at the bottom left corner of the radar display described in Section 2.3.2 is also
3 63
ON , they are selected in the