Table of Contents
Advertisement
During cutting, the gap between the blade tips (in the transverse direction) must not be
exceeded, otherwise the blade is in danger of breaking:
eDRAULIC cutting device
SC 258 E2
SC 358 E2
SC 757 E2
SC 758 E2
ATTENTION!
Where possible, avoid cutting through high-strength parts of the vehicle body
(e.g. side impact protection). This may result in damage to the blades or to
increased wear and tear!
Cutting with SC 358 E2, SC 757 E2 and SC 758 E2
The spreader tip of SC 358 E2, SC 757 E2 and SC 758 E2 can be removed. This prevents
the material from becoming stuck between the spreader tips, hindering the cutting process.
Removing the spreader tip
Step 1:
To remove the spreader tips, first push out bolt "A" a little, using a finger or an object. A fair
amount of force needs to be applied initially, as the bolt has a ball catch to prevent it from
falling out unintentionally.
max. gap at the blade tips
[mm]
/ [in.]
3
/ 0.12
3
/ 0.12
3
/ 0.12
3
/ 0.12
1.
A
2.
17
3.
Advertisement
Table of Contents
