Rear Panel - Plextor PX-W5224TA Installation And User Manual

Section 1. Getting Started

Rear Panel

Figure 2: Rear Panel of the PlexWriter 52/24/52A Drive
• Digital audio output connector: Outputs digital stereo signal. For connecting to
a sound board that supports Sony/Philips digital interface (SPDIF) or Digital-In.
• Analog audio output connector: Outputs an analog stereo signal for connecting
to a sound board or audio amplifier. Use a standard MPC-3 type, 4-pin connector.
• DMA jumper: Use the DMA jumper to convert between Ultra DMA Mode 0-2
(no jumper, default) and Multiword DMA Mode 0-2 (with jumper installed). In
general, leave this jumper at its factory setting, which is Ultra DMA (that is, no
jumper installed).
• Mode jumper: Use the mode jumper to select operation as an IDE master or
slave, or for cable select. In general, leave this jumper at its factory setting, which
is master.
• IDE cable connector: Connects to IDE (ATAPI) interface using 40-pin IDE flat
ribbon cable.
• Power connector: Connects to your computer's power supply to provide
DC +5 volts and +12 volts to the PlexWriter.
6
PlexWriter 52/24/52A Installation and Users Manual